3.5 Connecting components
This section describes how to connect components.
Select connection mode, by doing either of the following:
- Click the Connect button.
- Select Connect Ports Mode
from the Edit menu.
Move the mouse pointer around in the Block Diagram window:
|Not over an object
||The pointer changes to the invalid pointer, a circle with a
diagonal line through it.
|Over an object
||The pointer changes to the start connection pointer and the
closest valid port is highlighted.
Move the cursor so that it is over the
Clock component and close to the
clk_out port, then press
and hold the left mouse button down.
Move the cursor over the
Release the mouse button to connect the two ports.
The application remains in connect mode after the connection is
Make the remaining connections.
Figure 3-7 Connected components
Connections between the addressable bus ports have bold lines.