10.2.1. Implementation details

The following outputs are unconnected:

Note

Booting from memory controlled by the MPMC is not supported. Configuration signals relating to configuring the reset state of the MPMC are not used. You must configure the MPMC before you use it to control memory on either the dynamic or static memory buses.

The MPMCx signals from the configuration block (shown in Figure 10.1) are reserved for future use and are not supported in this release of the ARM926PXP development chip.

Copyright © 2004, 2006 ARM Limited. All rights reserved.ARM DDI 0287B
Non-Confidential