6.2. ATB replicator connection behavior

The ATB replicator is a rewiring unit for the connection of two trace sinks. Buses cannot be connected directly together.

The only design considerations are for:

Because of the simplicity of the block, no programmers model exists for this block. It is a requirement of the attached trace sinks to set their ATREADY signal when they are disabled. This enables the replicator to operate as a pass-through to the remaining enable trace sink.

Any connected blocks, on both the inputs and the outputs, must operate on the same ATCLK domain.

Copyright © 2004-2009 ARM. All rights reserved.ARM DDI 0314H
Non-Confidential