2.7.4. Trace start/stop control
The use of start/stop control can be enabled or disabled by
setting/clearing of the SSENABLE bit in the HTMTRACECTRL register.
If the SSENABLE bit is zero, the trace operates regardless of the
status of the trace start/stop control. The trace function can be
started or stopped automatically when a particular address is detected.
The Trace Start/Stop Resource Control Register, HTMSTARTSTOP, identifies
the single address comparators that hold trace start and stop addresses.
This 32-bit wide register is divided into:
- Lower half
Indicates which single address comparators are used
for start addresses.
- Upper half
Indicates which
single address comparators are used for stop addresses.
PDF version