5.1.3. Memory state control and status

You can change the state of the controller by programming the memc_cmd Register. See Table 3.4. A typical sequence is:

  1. Read the memc_status Register to check the status of the controller. See Memory Controller Status Register.

  2. When the controller is in the Config state you can initialize the controller as Memory controller initialization describes.

  3. Program the memc_cmd Register with the Go command to move the controller to the Ready state.

Initialize memory as described in Memory device initialization.

Copyright © 2004-2007, 2009 ARM Limited. All rights reserved.ARM DDI 0331G
Non-Confidential