A.3.4. Read address channel signals

Table A.6 shows the AXI read address channel signals. Unless the description indicates otherwise, these signals are used by the AXI3 and AXI4 protocols. For more information on each signal, see the ARM® AMBA® AXI and ACE Protocol Specification.

Table A.6. Write address channel signals

AXI signal NIC-400 adaptation[a]SourceDescription
arid_x[b][n:0]Master

Read address ID.

Where n is a variable.

  • For an ASIB, ID width {0-16} where 0 indicates that no value has been selected.

  • For an AMIB, one of the following parameters:

    • Global ID width {1-24}.

    • ID reduction. If selected, then the values can be viewed in the AMIBs ID reduction report from the GUI.

araddr_x[b][n:0]Master

Read address

Where:

n is equal to address width -1.

Address width is in the range of 32-64 bits.

arlen_x[b][3:0]MasterBurst length for AXI3.
arlen_x[b][7:0]MasterBurst length for AXI4.
arsize_x[b][2:0]MasterBurst size.
arburst_x[b][1:0]MasterBurst type.
arlock_x[b][1:0]MasterLock type for AXI3.
arlock_x[b]MasterLock type for AXI4.
arcache_x[b][3:0]MasterMemory type.
arprot_x[b][2:0]MasterProtection type.
arqos_x[b][3:0]MasterQuality of Service, QoS. Only when enabled from the GUI.
arregion_x[b][3:0]MasterRegion identifier. Only when enabled from the GUI and from a master interface of the NIC-400.
aruser_x[b][n:0]Master

User signal.

Where:

n is equal to user defined width -1.

A user-defined width is in the range of 0-256 bits.

If 0 is selected then the signal is not used.

arvalid_x[b]MasterRead address valid.
arready_x[b]SlaveRead address ready.

[a] You can select uppercase or lowercase signal names from the GUI.

[b] Where x is:

<port_name>_s

For a bridge slave interface.

<port_name>_m

For a bridge master interface.

<port_name>

For a system slave interface or master interface.


Copyright © 2012-2014 ARM. All rights reserved.ARM DDI 0475E
Non-ConfidentialID110314