A.3.5. Read data channel signals

Table A.7 shows the AXI read data channel signals. Unless the description indicates otherwise, these signals are used by AXI3 and AXI4 protocols. For more information on each signal, see the ARM® AMBA® AXI and ACE Protocol Specification.

Table A.7. Read data channel signals

AXI signal NIC-400 adaptation[a]SourceDescription
rid_x[b][n:0]Slave

Read ID tag.

Where n is a variable.

  • For an ASIB, ID width {0-16} where 0 indicates that no value has been selected.

  • For an AMIB, one of the following parameters:

    • Global ID width {1-24}.

    • ID reduction. If selected, then the values can be viewed in the AMIBs ID reduction report from the GUI.

rdata_x[b][n:0]Slave

Read data.

Where:

n is equal to data width -1.

Data widths can be 32, 64, 128 or 256 bits.

rresp_x[b][1:0]SlaveRead response.
rlast_x[b]SlaveRead last.
ruser_x[b][n:0]Slave

User defined signal.

Where:

n is equal to user defined width -1.

A user-defined width is in the range of 0-256 bits.

If 0 is selected then the signal is not used.

rvalid_x[b]SlaveRead valid.
rready_x[b]MasterRead ready.

[a] You can select uppercase or lowercase signal names from the GUI.

[b] Where x is:

<port_name>_s

For a bridge slave interface.

<port_name>_m

For a bridge master interface.

<port_name>

For a system slave interface or master interface.


Copyright © 2012-2014 ARM. All rights reserved.ARM DDI 0475E
Non-ConfidentialID110314