Disconnect any connections that are currently established.

In the Connection Control window, right-click on the connection that you want to configure.

Select Properties... from the context menu. The Connection Properties window is displayed, shown in Figure 6.16.

Figure 6.16. Connection Properties window

In the right pane, right-click on the BoardChip_name setting and select <More...> from the context menu. A List Selection dialog box is displayed.

Select ECT from the list, and click OK. A new BoardChip_name setting is created for the ECT.bcd file, shown in Figure 6.17.

Figure 6.17. ECT.bcd file assigned to a connection

Right-click on the BoardChip_name ECT setting, and select Jump to Definition from the context menu. The *BOARD=ECT entry is selected in the left pane, and the related settings are shown in the right pane, shown in Figure 6.18.

Figure 6.18. ECT.bcd settings

Modify the settings for the ECT as required.

You do not have to make any changes to the configuration settings in the ECT.bcd file. However, if you want to make changes, see the chapter that describes configuring custom targets in the RealView Debugger v3.0 Target Configuration Guide.

Select File ? Save and Close to save your settings and close the Connection Properties window.

When you connect to the target, an ECT tab is provided in the Registers pane, shown in Figure 6.19.