8.3. Running an image to a specific point

RealView Debugger gives you some control over how far an image runs before it stops, without having to set breakpoints.

Note

Be aware that when running to a specific point, RealView Debugger uses a temporary breakpoint to stop at the chosen point. However, if the chosen point is on ROM or Flash, RealView Debugger attempts to set a hardware breakpoint. If there are not enough breakpoint resources available, then RealView Debugger implements single instruction stepping, and displays the following warning:

Warning: Unable to set Software Break or Hardware Break at address, falling back to instruction stepping.

See also:

Copyright © 2002-2009 ARM Limited. All rights reserved.ARM DUI 0153K
Non-Confidential