13.22.1. Opening a user-defined window

To open a user-defined window:

  1. At the RealView Debugger CLI prompt in the Cmd tab, enter the command:

    Stop> VOPEN windowid

    where windowid is an integer in the range 50 to 1024 that identifies the window.

    For example:

    Stop> VOPEN 100

    A User window is displayed, shown in Figure 13.58.

    Figure 13.58. User-defined window

    User-defined window

  2. Specify the windowid in any CLI commands that support it.

    You can use the commands in scripts or macros, as required.

CLI commands that support user-defined window IDs

The following CLI commands support user-defined window IDs:

  • BREAKACCESS

  • BREAKEXECUTION

  • BREAKINSTRUCTION

  • BREAKREAD

  • BREAKWRITE

  • DCOMMANDS

  • DLOADERR

  • DOS_resource_list commands (for OS-aware targets)

  • DPIPEVIEW

  • DTBOARD

  • DTBREAK

  • DTFILE

  • DTRACE

  • EXPAND

  • FPRINTF

  • REGINFO

  • SHOW

  • VCLEAR

  • VCLOSE

  • VMACRO

  • VOPEN

  • VSETC.

Predefined macros that support user-defined window IDs

The following predefined macro supports user-defined window IDs:

  • fwrite.

See also

Copyright © 2002-2009 ARM Limited. All rights reserved.ARM DUI 0153K
Non-Confidential