11.2.1. Setting a breakpoint quickly

To set a simple breakpoint quickly:

  1. Connect to your target.

  2. Load the required image, for example dhrystone.axf.

  3. Click the tab for the required code view.

    For this example, click the dhry_1.c tab to view the source file dhry_1.c.

  4. Locate the source line or instruction in your code view where you want to set the breakpoint. For example, line 158 in dhry_1.c.

  5. Double-click on the margin to the left of the required source line or instruction. A simple breakpoint is set, as indicated by the red icon in the margin. Figure 11.2 shows an example.

    Figure 11.2. Breakpoint icon in the code view

    Breakpoint icon in the code view

See also

Copyright © 2002-2009 ARM Limited. All rights reserved.ARM DUI 0153K
Non-Confidential