A.1.1. Command

Settings in this group control the behavior and appearance of the Output view. Use these to:

When RealView Debugger starts, it uses the last-used settings unless overridden by settings in this group. These settings can be overridden dynamically by issuing CLI commands.

Saving changes takes immediate effect or at next start-up.

Table A.1 describes the settings.

Table A.1. Command settings

NameProperties
Num_lines

The height of the Output view. The default setting is 5 lines. Values can be entered in hex or decimal, for example 15 or 0x000F.

Radix_in

This setting specifies the format of number input options at start-up. The default format is decimal. However, you can enter hex numbers, for example ce number=0xABCD.

Switching to hex also enables you to enter decimal numbers, for example ce number=01234t.

Radix_out

This setting specifies number format output options at start-up. The default format is decimal.

Char

The way that char* and char[] values are displayed, for example as strings or values, for the PRINT command.

Uchar

The way that unsigned char* values are displayed, for example as strings or values, for the PRINT command.

Buffer_height

The number of lines of scrollback available in the Command area. The default is 1024 lines. Values must be greater than 32.

Changing this takes effect when RealView Debugger next starts.


Copyright © 2002-2009 ARM Limited. All rights reserved.ARM DUI 0153K
Non-Confidential