4.7. Replacing the currently loaded image

You do not have to unload an image from a debug target before loading a new image for execution.

To load over an existing image:

  1. Select Load Image... from the Target menu to display the Select Local File to Load dialog box. Figure 4.1 shows an example.

  2. Locate the new image to be loaded.

  3. Make sure the Replace Existing File(s) check box is selected on the Select Local File to Load dialog box, shown in Figure 4.1. This is the default setting.

  4. If you want to have control over whether the PC is set to the image entry point or not, then deselect the Auto-Set PC check box.

    The Set PC to Entry point check box is enabled.

  5. Click Open.

    All details about the first image are removed from RealView Debugger.

Copyright © 2002-2009 ARM Limited. All rights reserved.ARM DUI 0153K
Non-Confidential