8.4.4. Stepping a specified number of source lines

To step a specified number of source lines, you must use the CLI commands shown in Table 8.1. Each command accepts an integer value that specifies the number of lines of code to execute during the multiple step operation. During stepping, the number of steps remaining is displayed in the Code window status bar, for example, 87 Step Remaining.

Table 8.1. Commands for stepping by lines of code

Step controlCode ViewCommand
Step by line or instruction into functionsSource

STEPLINE n

(or STEP n)

Step by line or instruction over functionsSourceSTEPO n

See also

Copyright © 2002-2011 ARM. All rights reserved.ARM DUI 0153N
Non-ConfidentialID052111