14.1.1. Basic steps required for altering the target execution environment

To alter the target execution environment you must perform the following steps:

  1. Specify the point where target execution is to stop, and run the target to that point. You can specify where execution stops by:

    • setting a breakpoint that stops execution

    • running to a specific point

    • stepping.

  2. Examine and change the values of specific items. You can change the values of:

    • registers

    • memory locations

    • watches

    • the stack pointer.

    You can also read the contents of a file into memory, if required.

  3. Start execution again.

See also

Copyright © 2002-2011 ARM. All rights reserved.ARM DUI 0153N
Non-ConfidentialID052111