11.11. Finding a breakpoint in the code view

You can quickly locate a software instruction (Instr) or hardware execution (Exec) breakpoint in your code.

To view the location where a breakpoint is set:

  1. Select View → Break/Tracepoints from the Code window main menu to open the Break/Tracepoints view, if it is not already visible. Figure 11.15 shows an example:

    Figure 11.15. Breakpoint in the Break/Tracepoints view

    Breakpoint in the Break/Tracepoints view

  2. Right-click on the required breakpoint in the Break/Tracepoints view to display the context menu.

  3. Select View Code from the context menu. The code view changes to show the location of the breakpoint:

    • If the breakpoint was set using an address reference, then the location is shown in the Disassembly tab. Figure 11.16 shows an example.

    • If the breakpoint was set using a source line reference, then the location is shown in the source file tab.

    Figure 11.16. Locating a breakpoint

    Locating a breakpoint

Copyright © 2002-2011 ARM. All rights reserved.ARM DUI 0153N
Non-ConfidentialID052111