11.14.1. Setting a breakpoint on a single-statement line

To set a breakpoint on a single-statement line:

  1. Connect to a suitable target.

  2. Load the image to the target.

  3. Open the source file containing the line of source where you want to set the breakpoint.

  4. Double-click in the margin, that is the gray area to the left of a line, to set a simple breakpoint quickly. Figure 11.21 shows an example. You can also double-click on the line number if this is visible.

    Figure 11.21. Setting an unconditional breakpoint on a line

    Setting an unconditional breakpoint on a line

    This example sets a default software breakpoint marked by a red disc in the margin.

See also

Copyright © 2002-2011 ARM. All rights reserved.ARM DUI 0153N
Non-ConfidentialID052111