3.13.1. The connect modes

The connect modes available depend on your target:

Use default

This is the default option for all targets. When selected, the connect mode used depends on whether or not you have changed the Connect_mode setting in the connection properties for the connection:

  • If you have not set Connect_mode in the connection properties, then RealView Debugger connects using the default mode, No Reset and Stop.

  • If you have set Connect_mode in the connection properties, then RealView Debugger connects using the mode you have specified in the setting.

No Reset and Stop

Does not submit a processor reset but explicitly halts any process currently running by issuing a Stop command.

Note

This is the only mode available when connecting to a simulated target through the RVISS Debug Interface.

No Reset and No Stop

Does not submit a processor reset or attempt to halt any process currently running.

Reset and Stop

Submits a processor reset and explicitly halts any process currently running by issuing a Stop command.

Reset and No Stop

Submits a processor reset but does not attempt to halt any process currently running.

See also

Copyright © 2002-2011 ARM. All rights reserved.ARM DUI 0153N
Non-ConfidentialID052111