3.18.2. Setting disconnect mode for the current debugging session

To disconnect from a target using a specific disconnect mode:

  1. Select Target → Connect to Target... from the Code window main menu to open the Connect to Target window. If any targets are connected then the associated Debug Interface name is shown in bold text.

  2. Display the connected target:

    • In the Target grouping, expand the required Debug Interface.

    • In the Configuration grouping, expand the required Debug Interface and Debug Configuration.

  3. Select the target to be disconnected.

  4. In the Connection Mode group choose the required Disconnect Mode.

  5. Double-click on the target to disconnect.

    The target is disconnected, and the connection state changes to Not Connected.


When you set the disconnect mode in this way, the mode persists for the target only during the current debugging session. This enables you to temporarily override the Disconnect_mode setting in the connection properties.

See also

Copyright © 2002-2011 ARM. All rights reserved.ARM DUI 0153N