6.1.1. Requirements for writing binaries to Flash

To use RealView® Debugger to control Flash memory on your chosen debug target, you must:

You can set up the memory map in a separate Board/Chip Definition (BCD) file, which you can then assign to your target connection. RealView Debugger provides FME files and BCD files for supported targets:

If the FME files and BCD files provided do not meet your requirements, then you can create your own.

When you have configured your debug target to use the required BCD and FME files, you can program your Flash binary into the Flash device.

See also

Copyright © 2002-2011 ARM. All rights reserved.ARM DUI 0153N
Non-ConfidentialID052111