4.1. About loading images and binaries

When you start RealView Debugger you can begin to use some features such as editing and searching source code. However, to debug images and binaries you must first connect to a suitably configured debug target.

After starting RealView Debugger, and connecting to a debug target, you can:

The lists contain only those images and binaries that you have previously loaded for the type of target shown in the Code window.

The examples in this chapter assume that you are using a Typical installation and that the software has been installed in the default location. If you have changed these defaults, or set the environment variable RVDEBUG_INSTALL, your installation differs from that described.

See also:

Copyright © 2002-2011 ARM. All rights reserved.ARM DUI 0153N
Non-ConfidentialID052111