D.3. Probes, dimensions and keep out areas

Figure D.2 shows a single-connector Trace probe in RealView Trace attached to a target board.

Caution

The Mictor connector is not robust. It is recommended that the plastic shroud is fitted around the target connector. This part is not supplied as standard with RealView Trace.

The Mictor connector support shroud is available from Agilent as Part Number E5346 - 44701.

Figure D.2. Probe dimensions


Note

For information on dual-Mictor connector probes relating to RealView Trace 2 units, see Dual-Mictor trace probe.

Copyright © 2002, 2004-2008 ARM Limited. All rights reserved.ARM DUI 0155J
Non-Confidential