8.1.3. RealView ICE TCP/IP ports used

To use the RealView ICE Command Monitor and debug your target with GDB, RealView ICE uses the TCP/IP ports described in Table 8.1.

Table 8.1. RealView ICE TCP/IP ports

PortDescription
4000 series

The port range used in a one-up series (4001, 4002, 4003,...) to connect to a target from GDB, and to perform halt-mode debugging (see Halt-mode debugging).

5000 series

The port range used in a one-up series (5001, 5002, 5003,...) for Monitor-mode debugging and other Virtual Ethernet/TTY mode connections (see Monitor-mode debugging, and How connections to multiple processors are allocated).

Note

To use these ports you must set the DCC mode to a non-zero value (see DCC modes).


For information on allocating ports, see Port numbering.

Copyright © 2002, 2004-2008 ARM Limited. All rights reserved.ARM DUI 0155J
Non-Confidential