A.1. JTAG interface pinouts

The RealView ICE run control unit is supplied with a short ribbon cable, and a longer ribbon cable and LVDS probe. These both terminate in a 20-way 2.54mm pitch IDC connector. You can use either cable to mate with a keyed box header on the target. The pinout is shown in Figure A.1.

Figure A.1. JTAG interface pinout


Note

All GND pins must be connected to 0V on the target hardware.

Copyright © 2002, 2004-2008 ARM Limited. All rights reserved.ARM DUI 0155J
Non-Confidential