4.2. Using the RVConfig dialog box

Before you can use a RealView ICE run control unit to connect RealView Debugger to a target, you must configure the run control unit using the RVConfig dialog box. This procedure involves the following steps:

  1. Opening the RVConfig dialog box from RealView Debugger

  2. Opening the RVConfig dialog box — standalone method

  3. Connecting to a RealView ICE unit

  4. Configuring a scan chain

  5. CoreSight system configuration

  6. Configuring CoreSight cores

  7. Configuring devices

  8. Platform detection and selection

  9. Advanced configuration

  10. Saving your changes

  11. Disconnecting from a RealView ICE unit.

Copyright © 2002, 2004-2008 ARM Limited. All rights reserved.ARM DUI 0155J
Non-Confidential