E.1.1. End panel elements

The host computer ports end panel comprises:

The host computer ports end panel details are shown in Figure E.1.

Figure E.1. RVI v3.3 host computer ports end panel


Compare this arrangement with that of earlier units, an example of which is shown in Figure E.2.

Figure E.2. Pre-v3.0 host computer ports end panel


The main change in functionality between the v3.0 hardware and that of its predecessors was the introduction of the RST button. This enables you to reset the RVI to its default state without the requirement to disconnect the unit from the power supply and then reconnect. For more information on the functionality of each of the features shown in Figure E.1, see The RealView ICE run control unit.

In the case of the target hardware ports end panel, this shows the name of each of the four identification LEDs. See Figure E.3.

Figure E.3. RVI v3.3 target hardware ports end panel


Here, the identification LEDs JTAG, STAT, CFAC and LVDS replace the previous lettering system of A, B, C and D, respectively. An example of the replaced target hardware ports end panel is shown in Figure E.4.

Figure E.4. Replaced target hardware ports end panel


Copyright © 2002, 2004-2008 ARM Limited. All rights reserved.ARM DUI 0155J
Non-Confidential