3.3.2. Configuring using an Ethernet address

If you have a RealView ICE run control unit that does not have a valid IP address or is on a different subnet, you must manually enter the Ethernet address during configuration.

To configure your RealView ICE run control unit by entering an Ethernet address:

  1. Open the required configuration dialog box, depending on whether your run control unit has a USB connection:

    • If the device has a USB connection, select the device in the USB list and click the Configure tool. The Configure RealView ICE device dialog box appears, as shown in Figure 3.6.

      Alternatively, double-click on the device in the USB list.

    • If the device does not have a USB connection, click the Config New tool. The Configure new RealView ICE device dialog box appears, as shown in Figure 3.7.

    Figure 3.7. The Configure new RealView ICE device dialog box

    The Configure new RealView ICE device dialog box

  2. Determine the Ethernet address of your run control unit by reading the label on the side of the unit, and enter it into the Ethernet Address field.

    If you are using the Configure new RealView ICE device dialog box and you want to be certain that you are configuring the correct run control unit, click the Identify tool. Verify that the identification LEDs flash (see Figure 3.5).

  3. If you are using DHCP, select DHCP. Otherwise, deselect DHCP.

  4. Enter the hostname in the Host Name field. This must contain only the alphanumeric characters (A-Z, a-z, and 0-9) and the - character, and must be no more than 255 characters long.

  5. If you are not using DHCP, enter the required details in the following fields:

    • IP Address

    • Default Gateway

    • Subnet Mask.

    Note

    If you are using DHCP, you do not have to type these settings, because they are fetched from a DHCP server on your network.

  6. Select the required Ethernet Type:

    • if you know the type of network that you are using, select that type

    • otherwise, select Auto-Detect.

  7. Click Configure.

    The RealView ICE run control unit restarts. While it is restarting, it is not present in the list of units. When it has restarted, it re-appears in the list of units, with its new network settings.

    Note

    If the RealView ICE run control unit is using DHCP, the list of units might display its IP Address as 127.0.0.2. This is a dummy address that the run control unit uses when it fails to obtain an IP address from the DHCP server.

    The list of units shows the correct address if the DHCP server has assigned it.

Copyright © 2002, 2004-2008 ARM Limited. All rights reserved.ARM DUI 0155J
Non-Confidential