Chapter 3. Configuring RealView ICE Networking

This chapter describes how to configure the network settings for your RealView® ICE run control unit. If you have connected your run control unit to an Ethernet network or directly to the host computer using an Ethernet cross-over cable, you must configure the network settings before you can use the unit for debugging. You have only to configure the network settings once.

Note

If you have connected your run control unit directly to the host computer using a USB cable, and you do not intend to connect it to a network, you do not have to configure the network settings. See Connection instructions for information on connecting up the components.

To configure your RealView ICE run control unit to use the correct network settings for your network:

  1. Determining the correct network settings

  2. Starting the RealView ICE Config IP application

  3. Configuring the network settings

  4. Restarting your RealView ICE run control unit

  5. Exiting the RealView ICE Config IP application.

Copyright © 2002, 2004-2008 ARM Limited. All rights reserved.ARM DUI 0155J
Non-Confidential