1.3.3. Care of connectors

This section contains advice about how to prevent damage to the connectors on Integrator modules.

Caution

To prevent damage to your modules, observe the following precautions:

  • When separating modules, take care not to damage the connectors. Do not apply a twisting force to the ends of the connectors. Loosen each connector first before pulling on both ends of the module at the same time.

  • Use the Integrator system in a clean environment and avoid debris fouling the connectors on the underside of the PCB. Blocked holes result in damage to connectors. Visually inspect the module to ensure that connector holes are clear before mounting modules onto the Integrator.

Copyright © 2002 ARM Limited. All rights reserved.ARM DUI 0159B
Non-Confidential