2.5.2. Possible effect on remap of using a debugger

When the Integrator system is powered up, the boot code area of flash is mapped at address 0x00000000. Before you can access SSRAM at this address, you must remap the memory to replace the flash with the SSRAM. Occasionally however when using a debugger, the boot monitor does not run after power up and therefore does not remap the memory. (This might happen for example, if the debugger has set a breakpoint on the exception vectors.) If this happens, write to the appropriate core module register before loading code at address 0x00000000.

Copyright © 2002 ARM Limited. All rights reserved.ARM DUI 0159B