| Copyright © 2002-2010 ARM Limited. All rights reserved. | ARM DUI 0175M |
| Non-Confidential | ID102410 |
 PDF version | |
| Home > RealView Debugger Commands > Alphabetical command reference > DELBOARD |
| |||
| Home > RealView Debugger Commands > Alphabetical command reference > DELBOARD | |||
Temporarily deletes a Debug Configuration entry from the displayed list.
DELBOARDresource,...]
where:
resourceThe name of the Debug Configuration that is to have its entry deleted from the list.
Use this command to temporarily delete a Debug Configuration that does not have any targets connected. Also, if you are using the Configuration grouping in the Connect to Target window, then the Debug Configuration must not have been expanded to show the list of targets. If you specify a Debug Configuration that has a target connected, or has been expanded, then the following message is displayed:
Board n is connected - cannot delete.
If you do not specify a Debug Configuration, all Debug Configurations that do not have targets connected are deleted.
The Debug Configurations are not deleted from the board file
(.brd). The deleted Debug Configuration becomes
available again you issue a READBOARDFILE command
or restart the debugger. However, you must disconnect from all connected
target first.
To temporarily delete the RVISS_2 Debug
Configuration, enter:
delboard ="RVISS_2"
This command deletes the Debug Configuration NAME RVISS_2.
The target for this configuration must not be connected when the
command is issued.
the following in the RealView Debugger Target Configuration Guide:
| Copyright © 2002-2010 ARM Limited. All rights reserved. | ARM DUI 0175M |
| Non-Confidential | ID102410 |
| PDF version | |
| Home > RealView Debugger Commands > Alphabetical command reference > DELBOARD |