2.3.114. RUN

Starts execution using a specific mode, or sets the default mode used by the GO command.

Syntax

RUN

RUN ,setdefault

RUN [,setdefault],{debug|normal}

RUN [,setdefault],{clock|benchmark}

RUN [,setdefault],{free|user}

where:

setdefault

Set the default mode for the GO command to the mode specified by this command, but do not start execution.

If no mode is specified, then the default mode (debug or normal) is set.

debug | normal

Run with breakpoints active. This is the default mode.

clock | benchmark

Run with breakpoint timing hardware enabled. This mode is only available on some targets.

free | user

Run at full speed, with breakpoints disabled. Depending on the target, hardware, this might not be any faster than normal mode.

Description

If supported by the target, the RUN command starts execution using a specific mode, or sets the default mode used by the GO command.

If you supply no parameters, RUN displays the current mode.

Examples

The following examples show how to use RUN:

run,setdefault,normal

Set the default run mode to normal, so that the next GO command for this connection runs the target in the normal way.

run,free

Run the target with breakpoints disabled.

See also

Copyright © 2002-2011 ARM. All rights reserved.ARM DUI 0175N
Non-ConfidentialID052111