5.14.3. Reconnecting to a target

RealView Debugger saves all open connections in the current workspace if you close down without disconnecting first. This default behavior is independent of the status of the Disconnect Connection check box shown in Figure 5.12.

This means that, if you exit a session when still connected to a debug target, RealView Debugger tries to reconnect when you next open the workspace. However, this might fail if the connection or vehicle status has changed, for example if your RealView ICE interface has been disconnected or if your Multi-ICE® server has stopped.

If RealView Debugger reconnects successfully, the connection mode specified in the target configuration file is used by default. See the chapter that describes connecting in RealView Debugger v1.8 Target Configuration Guide for full details on defining the connect mode for your debug target.

Note

Use your settings options to change the way RealView Debugger closes down, see Settings options for details.

Copyright © 2002-2005 ARM Limited. All rights reserved.ARM DUI 0181G
Non-Confidential