7.4.2. Connecting to a debug target

Use the CONNECT command to connect to a debug target. You must specify the access-provider connection, then the endpoint connection.

Note

Use named connections when using the headless debugger.

For example, to connect to RealView ARMulator® ISS (RVISS) through the localhost Simulator Broker:

  1. Connect to the route (access-provider connection):


    connect,route @localhost

    The following messages are displayed:


    =  3. Board Entries added/modified
    TVS>

  2. Connect to RVISS (endpoint connection):


    TVS> connect @new_arm
    =  4. CONNECT: Board Simarm_1 (Sim) is now connected
    ...
    Stop>

Copyright © 2002-2005 ARM Limited. All rights reserved.ARM DUI 0181G
Non-Confidential