3.10.2. Reconnecting to a target

RealView Debugger saves all open connections in the current workspace if you close down without disconnecting first. This means that RealView Debugger tries to reconnect when you next open the workspace. However, this might fail if the connection or Target Access status has changed, for example if your RealView ICE interface has been disconnected or if your Multi-ICE® server has stopped.

If RealView Debugger reconnects successfully, the connection mode specified in the target configuration file is used by default. See the chapter that describes target connection in the RealView Debugger v3.0 User Guide for full details on defining the connect mode for your debug target.

Copyright © 2002-2006 ARM Limited. All rights reserved.ARM DUI 0181H