A.1.9. Changes to the CLI commands and predefined macros

This section describes the changes that have been made to the CLI commands and predefined macros.

See the RealView Debugger Command Line Reference Guide for full details.

Connection CLI commands

The following change has been made to the connection CLI commands:

  • The DISCONNECT command now has the debug and nodebug qualifiers for specifying the disconnect mode.

OS-aware CLI commands

The following change has been made to the OS-aware CLI commands:

  • If your OS-aware plug-in supports event debugging, then the OSCTRL command enables you to specify events and filters for the selective loading of debugging symbols.

See the RealView Debugger RTOS Guide for more details on using the events and filters.

Trace CLI commands

The following changes have been made to the trace CLI commands:

  • The TRACEDATAACCESS, TRACEDATAREAD, TRACEDATAWRITE, TRACEINSTREXEC, and TRACEINSTRFETCH commands enable Secure world and Normal world data comparisons for processors that implement the TrustZone architecture.

  • The TRACEEXTCOND command supports extended external inputs 1 to 4, for ETMv3.1 and later.

  • The TRACEBUFFER command includes an option to invert the sense of the specified filter conditions.

  • The ETM_CONFIG command enables you to specify:

    • values for extended external inputs 1 to 4, for ETMv3.1 and later

    • a synchronization frequency, for ETMv2 and later.

Other CLI commands

The changes made to other CLI commands are as follows:

  • the BREAKACCESS, BREAKEXECUTION, BREAKINSTRUCTION, BREAKREAD, and BREAKWRITE commands enable you to specify an address prefix to identify Secure world and Normal world addresses on a TrustZone-enabled target

  • the DISASSEMBLE command enables you to show Thumb-2EE disassembly

  • the LOAD command enables you to load images to either the Secure or Normal world on a TrustZone-enabled target

  • the access size options of the READFILE, VERIFYFILE, and WRITEFILE commands have changed

  • the SETTINGS command no longer supports the project-related settings

  • a new STATS command enables you to display bus and processor cycles for RVISS targets.

Predefined macros

The following change has been made to the predefined macros:

  • There is a new fclose macro to complement the fopen macro.

Copyright © 2002-2007 ARM Limited. All rights reserved.ARM DUI 0181I
Non-Confidential