6.1. Accessing remote targets with RealView
ICE and Multi-ICE
RealView Debugger enables you to debug software running on targets
connected to remote hosts, that is where hardware is connected to
workstations accessed across the network. To do this, you must use
the appropriate configuration dialog to locate the target:
If you are using RealView ICE, enter the address
of the remote unit in the RVConfig dialog box. See Configuring a RealView ICE interface
unit for details.
If you do not know these details, use the RealView ICE Config
IP software to scan for all available units on your network. See
the chapter that describes configuring RealView ICE networking in RealView
ICE User Guide for details on how to do this.
If you are using Multi-ICE® on
Windows, click Another computer... on the Multi-ICE
DLL configuration dialog box to locate all workstations on your network
that are running the Multi-ICE server software. See Configuring ARM Multi-ICE for details.
Note
Multi-ICE direct connect is the only way to connect to Multi-ICE
where you are working on Sun Solaris or Red Hat Linux (see Working with RealView Network Broker for more details).
PDF version