6.3.3. Viewing remote simulator connections

When you connect to a remote target, a new entry appears in the Connection Control window, for example RSimarm_1, as shown in Figure 6.6.

Figure 6.6. Remote connections in the Connection Control window

Remote connections in the Connection Control window

Here you can see two connections to remote RealView ARMulator® ISS targets. In this example, the IP address has been used to specify the host workstation. Other remote connections are visible depending on the type of installation at the remote workstation. Where you have the appropriate licenses, you can connect to these simulators in the usual way.

Note

Ending a debugging session on the remote workstation, and closing down RealView Debugger, does not terminate the remote connection broker. RealView Network Broker must be shut down explicitly when it is no longer required.

Copyright © 2002-2005 ARM Limited. All rights reserved.ARM DUI 0182G
Non-Confidential