| |||
| Home > Customizing a Debug Configuration > Configuring RealMonitor for connections through RealView ICE > Customizing the Debug Configuration used for enabling RealMonitor | |||
To configure the Debug Configuration used for enabling RealMonitor (see the RealView ICE and RealView Trace User Guide for more details):
Right-click on the new
Debug Configuration (RVI_RM_Run) to display the
context menu.
Select Configure... from the context menu to display the RVConfig dialog box.
Select your RealView ICE hardware from the list of devices.
Click Connect... to connect to RealView ICE.
If your Debug Interface has targets that:
can be halted and do not contain any DSPs, then click Auto Configure Scan Chain
must not be halted or has DSPs, then add the devices manually.
Click Advanced, and change the
settings as shown in Table 3.8.
Leave all other settings unchanged.
Table 3.8. RealView ICE settings for RealMonitor
| Setting | Value |
|---|---|
Reset Type | nTRST |
Default Post Reset State | Running |
TAP reset via State Transitions | unselected |
The intention here is to make sure that your development platform is not reset, and that the target is always running. Some targets might require different settings.
Select Save from the File menu to save the changes.
Select Exit from the File menu to close the RVConfig dialog box.
the following in the RealView Debugger User Guide:
| Copyright © 2002-2007 ARM Limited. All rights reserved. | ARM DUI 0182I |
| Non-Confidential | |
 PDF version | |
| Home > Customizing a Debug Configuration > Configuring RealMonitor for connections through RealView ICE > Customizing the Debug Configuration used for enabling RealMonitor |