The Connect to Target window displays:
a list of the Debug Interfaces that are currently installed
the Debug Configurations that you have created for each Debug Interface
the targets within each Debug Configuration to which you can connect.
Figure 1.2 shows an example Connect to Target window with RealView ICE installed.
There are two groupings available for viewing the connections:
- Target
The Target grouping shows all target connections as a list for each Debug Interface. The Debug Configuration name to which each target is associated is listed in the
Configurationcolumn, shown in Figure 1.2.- Configuration
The Configuration grouping shows the target connections grouped by the related Debug Configuration. You are recommended to use this grouping when you add, copy, rename, customize, or delete a Debug Configuration. Figure 1.1 shows an example of this grouping.
You can use the Connect to Target window to:
Establish connections to the targets in your development platform, either individually or in a single operation.
Add Debug Configurations and customize them to define specific debugging environments for your specific requirements. For example, you might have one Debug Configuration that you use for OS-awareness debugging, and another for basic debugging. The remainder of this document describes how to add and customize Debug Configurations.
The Debug Interfaces available to you depend on what you have installed.
The following Debug Interfaces are provided as installation options with RealView Development Suite (RVDS):
RealView Instruction Set Simulator (RVISS), which is always installedInstruction Set System Model (ISSM), which is an installation optionARM Ltd. Direct Connectionfor the Versatile Platform for ARM926EJ-S™ (USB port), which is an installation option (you must purchase the hardware separately).
The following Debug Interfaces are also available if you have purchased and installed the related products:
RealViewICEis available only if you purchase and install RealView ICE.Note
This document assumes that you have installed the host software and firmware for RealView ICE v3.1.
SoC Designeris always listed in the Connect to Target window. However, you must purchase and install RealView SoC Designer to create Debug Configurations for SoC Designer models.
Note
If you have installed a Real Time System Model (RTSM),
no separate Debug Interface is provided. You access the RTSM using
the Instruction Set System Model (ISSM) Debug
Interface.
Chapter 3 Target Connection in the RealView Debugger User Guide.
PDF version