RealView Debugger Target Configuration Guide: A.3.7. Pre

Forces an order for target connection. This depends on whether the name of the Advanced_Information block is Default or has a target name:

If the name is Default, then this setting operates in the same way as the generic Pre_connect setting.
If the name is a target name, for example ARM940T, then this setting identifies one or more targets that are to be connected before the ARM940T processor. This setting is used:
- when you connect to the named target
- the named target is connected as part of another Pre_connect sequence.

If a listed target is already connected, then no attempt is made to re-connect to that target.

For each target you want to pre-connect:

Specify the full connection name for the target. That is, the name as it appears in the Connect to Target window, for example ETM_1.
Press Enter to complete the entry.
A new Pre_Connect entry is created for the target.

The targets are listed in reverse order. Therefore, the last target you enter is connected first.

Copyright © 2002-2010 ARM Limited. All rights reserved.	ARM DUI 0182M
Non-Confidential	ID102410
PDF version