A.3.8. Commands

This enables you to specify RealView Debugger commands to run after a target connection is established. The most common example is to include commands from a file, using the INCLUDE command. The commands are run immediately after the connection is completed.

Considerations when using Commands settings

Be aware of the following:

  • If the commands are defined in the Default group of the Advanced_Information block, the commands are executed when you connect to each target in a multiprocessor Debug Configuration.

  • If the commands are defined in a target-specific group of the Advanced_Information block, the commands are executed only when you connect to a target that matches the group name.

See also

Copyright © 2002-2011 ARM. All rights reserved.ARM DUI 0182N
Non-ConfidentialID052111