3.6. Specifying connect and disconnect mode

If you want to specify how RealView Debugger connects to or disconnects from a target processor, you must configure this at the CONNECTION level. These definitions are contained in the Advanced_Information group for the target processor.

Note

The connect or disconnect mode that is used depends on the target hardware, the Debug Interface, and the associated interface software that manages the connection. For example, if you are using DSTREAM or RealView ICE, the unit configuration can specify the disconnect mode. Therefore, the unit configuration might override any settings that you specify in your board file.

See also:

Copyright © 2002-2011 ARM. All rights reserved.ARM DUI 0182N
Non-ConfidentialID052111