| Copyright © 2002-2003. All rights reserved. | ARM DUI 0184B |
| Non-Confidential | |
 PDF version | |
| Home > CP Image for Operation with an Integrator/CP Baseboard > About the CP PLD image > Selecting the CP image on a core module mounted on an Integrator/CP |
| |||
| Home > CP Image for Operation with an Integrator/CP Baseboard > About the CP PLD image > Selecting the CP image on a core module mounted on an Integrator/CP | |||
To select the CP image on a core module mounted on an Integrator/CP, set the DIP switches as follows:
S1[1] = x (x= don’t care)
S1[2] = x
S1[3] = OFF
S1[4] = OFF.
The baseboard drives the signals CFGSEL[1:0] correctly to select the correct image, see PLD image selection.
This image is signified by the code 0b00110011 being
displayed by the user LEDs (0=OFF, 1=ON) when the system is powered
ON.
The bit file for the CP image is supplied on the CD for the CM922T-XA10 and is programmed into the image flash during board manufacture and test. However, the source files for the image are supplied with the CP baseboard.
Reprogramming of the core module must be performed standalone (that is, without a baseboard attached). Reprogramming requires code to be run on the processor. If a baseboard is attached, however, the processor is held in reset until configuration is complete.
| Copyright © 2002-2003. All rights reserved. | ARM DUI 0184B |
| Non-Confidential | |
| PDF version | |
| Home > CP Image for Operation with an Integrator/CP Baseboard > About the CP PLD image > Selecting the CP image on a core module mounted on an Integrator/CP |