The VFPASSERT SCALAR directive informs the assembler that following VFP instructions are in scalar mode.




Use the VFPASSERT SCALAR directive to mark the end of any block of code where the VFP mode is VECTOR.

Place the VFPASSERT SCALAR directive immediately after the instruction where the change occurs. This is usually an FMXR instruction, but might be a BL instruction.

If a function expects the VFP to be in vector mode on exit, place a VFPASSERT SCALAR directive immediately after the last instruction. Such a function would not be AAPCS conformant. See the Using the Procedure Call Standard appendix in RealView Compilation Tools v2.2 Developer Guide for more information.

See also:


This directive does not generate any code. It is only an assertion by the programmer. The assembler produces error messages if any such assertions are inconsistent with each other, or with any vector notation in VFP data processing instructions.

The assembler faults vector notation in VFP data processing instructions following a VFPASSERT SCALAR directive, even if the vector length is 1.


    VFPASSERT   SCALAR            ; scalar mode
    faddd       d4, d4, d0        ; okay
    fadds       s4<3>, s0, s8<3>  ; ERROR, vector in scalar mode
    fabss       s24<1>, s28<1>    ; ERROR, vector in scalar mode
                                  ; (even though length==1)
Copyright © 2002-2005 ARM Limited. All rights reserved.ARM DUI 0204F