3.8.1. JTAG connection

Figure 3.13 shows the JTAG connector, CFGEN link and LED.

Figure 3.13. JTAG connector, CFGEN link, and LED

The CONFIG link is used to enable in-circuit programming of the FPGA and PLD using Multi-ICE and the progcards utility (see JTAG connection modes).

The JTAG connector provides a set of JTAG signals that allow JTAG debugging equipment to be used (see JTAG signals). If you are debugging a development system with multiple tiles, connect the JTAG debugging equipment to the IM-LT3 and the JTAG signals are routed through any connected tiles.

Copyright © 2005, 2006 ARM Limited. All rights reserved.ARM DUI 0216B
Non-Confidential