4.5. Reprogramming the PLD

The IM-LT3 is supplied with the PLD already programmed. The information in this section is provided, however, in case of accidental erasure of the PLD or to update the PLD with a new design from ARM Ltd.

Caution

You are advised not to reprogram this device with any images other than those provided by ARM.

Program the PLD as follows:

  1. Put the IM-LT3 into configuration mode by fitting the CONFIG link (J14) and power-up.

  2. Start the Multi-ICE server and the load the configuration file (.cfg) for the IM-LT3.

  3. Start a command prompt and move to the configure directory.

  4. Run the progcards utility.

  5. Choose the required PLD image.

Copyright © 2005, 2006 ARM Limited. All rights reserved.ARM DUI 0216B
Non-Confidential