A.2.1. Pos_size

Settings in this group control the position on screen and the size of Code windows in lines and characters. Use these to customize the size and position of Code windows in RealView Debugger.

On start-up, RealView Debugger uses the last-used settings unless overridden by these settings. As you open new Code windows in the session, they are controlled by these settings.

Table A.3 describes the settings.

Table A.3. Pos_size settings

NameProperties
Num_lines

Use this to specify window height as a given number of lines. The default is 0x0200.

Num_chars

Use this to specify window width as a given number of characters. The default is 0x02A0.

X_pos

Use this to specify the X position of the top-left corner of the window. The default is 0x010F.

Y_pos

Use this to specify the Y position of the top-left corner of the window. The default is 0x0066.

Copyright © 2003, 2004 ARM Limited. All rights reserved.ARM DUI 0234B
Non-Confidential