A.1.1. Command

Settings in this group control the behavior and appearance of the Code window command line and Output pane. Use these to customize the input and output format used in this area.

When RealView Debugger starts, it uses the last-used settings unless overridden by settings in this group. These settings can be overridden dynamically by issuing CLI commands.

Saving changes takes immediate effect or at next start-up.

Table A.1 describes the settings.

Table A.1. Command settings

NameProperties
Num_lines

The height of the Output pane. The default setting is 5 lines. Values can be entered in hex or decimal, for example 15 or 0x000F.

Radix_in

This setting specifies the format of number input options at start-up. The default format is decimal which allows hex numbers to be entered, for example 0xABCD and 0’ABh.

Switching to hex allows decimal numbers to be entered, for example 01234t.

Radix_out

This setting specifies number format output options at start-up. The default format is decimal.

Char

The way that char* and char[] values are displayed, for example as strings or values, for the PRINT command.

Uchar

The way that unsigned char* values are displayed, for example as strings or values, for the PRINT command.

Buffer_height

The number of lines of scrollback available in the Command area. The default is 1024 lines. Values must be greater than 32.

Changing this takes effect when RealView Debugger next starts.

Copyright © 2003, 2004 ARM Limited. All rights reserved.ARM DUI 0234B
Non-Confidential