If you had not yet loaded a model at the time that Model Debugger
In the Load Model dialog box that appears, locate
and select the required model, then click Open.
A dialog box appears:
Figure 2-2 Configure Model Parameters dialog box
If you had already loaded a model before Model Debugger starts, Model Debugger checks the
available components and opens a similar dialog box.
The exact contents and titles of the panes might differ because they depend on the model.
The Configure Model Parameters dialog box has the following sections:
This pane contains a hierarchical list of the component
parameters by category. Click the + symbol
to expand the view or the - symbol to collapse
- Parameter setting
The parameter values are displayed in the right-hand
Use the box in the lower left corner of the window to toggle
between hexadecimal or decimal views.
The name of this pane varies, depending on the model, but
its purpose and usage is the same in all cases.
To view all of the configuration parameters as a single list, click the List
View tab. The Tree View is similar, but shows the same
parameters in a grouped hierarchy.
Figure 2-3 Configure Model Parameters dialog box,
List View tab
Set the parameters for the model and click OK to
close the Configure Model Parameters dialog box.